Slin Pins

[LebanonDon]

I picked up some 29g 1/2 inch insulin pins because i read here that some guys use them for their delts and my last injection hurts like a mofo and is bruised. Do i use the same pin to draw the oil and inject cause it only came with one. I feel like its gonna take forever to draw and inject through the tiny needle.

 

[weights=life]

Lol back load it. What i mean is take the plunger out and fill it up use a 21 guage to draw

 

[alphamale_devon]

Or just take a cup of water put it in the microwave boil it then throw the syringe that has gear in the cup for 2-3 mins take it out inject Painless as fuck. As if you never pinned there before. I wouldn't use slin pin to inject oil. It takes a long time and the pins are flimsy to the point to where if you don't have a steady hand it could break in your inject spot.

 

[China_Wall]

draw with a slin pin... now that is some funny shit haha

like said above, u gotta backload them bro... and with a slin pin the most u can get into them is about .8ml as u gotta leave some room to put the plunger back in. Not worth the hassle in my mind

 

[Clicked]

18g to draw
23g to pin

done in two minutes

 

[LebanonDon]

Seems like alot of hassle, thanks guys im just gonna stop being a pussy and use a normal syringe. I was also wondering if i could break it in my arm, not down! Im curious about the backloading, wont the gear leak out the pin when you put the oil in without the plunger making a vacum or is it too thick to move through the pin unless you force it from the plunger?

 

[dfeaton]

Seems like alot of hassle, thanks guys im just gonna stop being a pussy and use a normal syringe. I was also wondering if i could break it in my arm, not down! Im curious about the backloading, wont the gear leak out the pin when you put the oil in without the plunger making a vacum or is it too thick to move through the pin unless you force it from the plunger?

Lol, no the needle won't break. No the gear won't leak out if done right. Don't over think it. It's a real simple process.

 

[Controlfreak]

I use this process for my tren ace pins and it works great. when the vacume is created you lose a miniscule portion of gear as the "bubble" makes its way to the top of the pin to be froced out. very minimal amount. it make for a long pin though onsidering its coing out of a 29g needle but I have yet to have any pain from it