Splitting Tablets into 4th's

omgmike1

New member
I'm buying adex tabs that are 1mg. Not sure if they are circular or tube shaped, but they will be tablet form for sure.

I'm looking to get .25 out of them. I know the basic method of pill cutters to break them into .5 mg, but is there any way to get them into .25 tablets?

Maybe a certain pill cutter anyone can recommended that can do this job or is there another method?
 
Tough to get them split on correct dosage even in half. I have pharmacy grade from Dr fir trt and have been stock piling them.

I use RUI liquid adex and never had an issue with my e2 once dialed in on trt or on a blast/cruise The liquid makes it much easier.

Just my opinion.
 
Just cut them in half with the pill cutter and then cut the halfs in half again with the pill cutter or snap them with your fingers. It wont be as accurate as the liquid form but it will be close enough.
 
I feel your pain bro...

Arimidex are tiny, splitting into 4 is almost impossible... I dose my Adex at 0.5mg E4D.... and then adjust according to bloods...

Try splitting those tiny things into 0.25mg and you'll lose most of your tab as powder.
 
I feel your pain bro...

Arimidex are tiny, splitting into 4 is almost impossible... I dose my Adex at 0.5mg E4D.... and then adjust according to bloods...

Try splitting those tiny things into 0.25mg and you'll lose most of your tab as powder.

That's probably what I would do. ^

I have seen pill splitters that can do quarters, but Ben's idea is probably the best, aside from picking up liqudex from the lion.
 
That's probably what I would do. ^

I have seen pill splitters that can do quarters, but Ben's idea is probably the best, aside from picking up liqudex from the lion.


Any other way, I dont have liquidex, I ordered like 2 packs of adex 1mg tablets from PSL. I'd like a accurate reading, so I know this method sounds brutal, but I was thinking of buying a .001g scale and massing 1 pill, then diiving it by 4, then crushing the adex crap into powder, then massing small spoons or something of adex powder and just taking it with water? Pain in the butt, but better than guessing I'd say.. Thoughts?
 
Any other way, I dont have liquidex, I ordered like 2 packs of adex 1mg tablets from PSL. I'd like a accurate reading, so I know this method sounds brutal, but I was thinking of buying a .001g scale and massing 1 pill, then diiving it by 4, then crushing the adex crap into powder, then massing small spoons or something of adex powder and just taking it with water? Pain in the butt, but better than guessing I'd say.. Thoughts?

That would be operating under the assumption that the active ingredient is spread homogeneously throughout the powder. As there's no way of knowing what is filler and what isn't, you would be taking an unnecessary risk.
 
Just cut them in half with the pill cutter and then cut the halfs in half again with the pill cutter or snap them with your fingers. It wont be as accurate as the liquid form but it will be close enough.

Yes, this works well enough. I'm on trt, and I take 1/4 pill of anastrozole twice a week. I've been cutting the pill in quarters for almost 2 years now. It's worked pretty well with a pill cutter from walgreens.
 
You can find a decent pill cutter ar any CVS or Walgreens... of look for a medical supply store
which might give you a higher grade or better quality splitter.

I don't run Adex but studies show EOD to be sufficient... and would be my personal first choice.
 
Life got easier with cutting AI when I went pharmaceutical. They are a bit bigger, pretty easy to cut into 1/4's
 
I'm buying adex tabs that are 1mg. Not sure if they are circular or tube shaped, but they will be tablet form for sure.

I'm looking to get .25 out of them. I know the basic method of pill cutters to break them into .5 mg, but is there any way to get them into .25 tablets?

Maybe a certain pill cutter anyone can recommended that can do this job or is there another method?

use cutter to cut in half, then twist tabe and cut into 4 parts.
 
Back
Top