Suspension in oil...crystals?

[!@#$%^&]

What do i do about this? I can see HUGE and TONS of crystals in the suspension. It says

Sterile Ethyl Oleate based injectable
2% benzyl alcohol
20% benzyl benzoate

50mg/ml

 

[DocJ]

1. Heat before use.
2. Tell the lab they're morons for not being able to make this properly

 

[zephyrdaz]

1. Heat before use.
2. Tell the lab they're morons for not being able to make this properly

^^ Lol ^^

It's crashed, It happens sometimes. Give it a good warm for a bit and a good swirl about and it should be fine.

 

[!@#$%^&]

How do you heat it?

Do i have to heat it before every use?

 

[!@#$%^&]

How do you heat it?

Do i have to heat it before every use?

^^

 

[MOE from H.P.]

run it under warm tap water. ive heard you can use the microwave to nuke it but i wouldnt do that. if the crystals reappear then yes you will have to heat it every time.

 

[zephyrdaz]

How do you heat it?

Do i have to heat it before every use?

Hopefully you wont have to heat it every time, if it was me I'd bin it if it didn't work. But gears easier to get hold of over here.

Doubt the tap will get it warm enough, best thing is to stick it in the microwave a couple of seconds at a time and shake it really hard.

Let me know how it goes.

And as the Doc said, tell that lab to stop sending you shit gear!!

 

[DocJ]

Putting it under the tap might work if it gets warm enough and if there aren't a lot of crystals but yes you may need to nuke it briefly if that doesn't work.