test cyp looks cloudy and milky

[mike67]

my vial of cyp has taken on a milky type appearance..its not old or anything but its never looked that way before...what gives?im hesitant to shoot this into myself...haha

 

[Southernfish]

is it actually a milky color or has it start forming crystals?

 

[Daniel_IMT_Staff]

Hello,

Sometimes the vials can look funny because it is filled with small air bubbles but you are saying you had this vial and after a while of using it turned milky and you haven't re-inserted any of the T?

 

[mike67]

actually,when i turn it upside down and the test moves to the top of the vial there is a mass of stuff stuck to the bottom..i guess these are the crystals you mentioned?is this a big deal?is this vial useless now?
to the second poster,ive had this for about 4 months and never noticed it until today..i admit,i have issues drawing sometimes and i reinject the test back into the vial and redraw..is that a bad thing?

 

[Southernfish]

actually,when i turn it upside down and the test moves to the top of the vial there is a mass of stuff stuck to the bottom..i guess these are the crystals you mentioned?is this a big deal?is this vial useless now?
to the second poster,ive had this for about 4 months and never noticed it until today..i admit,i have issues drawing sometimes and i reinject the test back into the vial and redraw..is that a bad thing?

If they are in fact crystals in the vial, your gear has crashed. You can reheat it in the oven at a very low temp, and it will return back to normal. You can also run it under hot water for a while and this can work as well. If you do the over method, 150 should work for temp and make sure you put a pin in the stopper so pressure doesn't build up in the vial.

This is all if they are in fact crystals in the vial.

 

[mike67]

thanks!i also noticed tiny shards in the liquid...def gonna heat it and salvage it...so if i run it under hot water just do it until its clear again and shake it i guess?

 

[Southernfish]

thanks!i also noticed tiny shards in the liquid...def gonna heat it and salvage it...so if i run it under hot water just do it until its clear again and shake it i guess?

Ya its def crashed if you see little shards it in. Id try hot water first, if they crystals aren't that big and clumpy that should do the trick, just get the water nice and hot and give er. I wouldn't shake it after you get it back to good just give it a swirl around a few time so its all mix up again.

 

[mike67]

ok thanks...and if it happens again is it cool to keep reheating the same vial?
also...what causes this anyhow?

 

[Southernfish]

ok thanks...and if it happens again is it cool to keep reheating the same vial?
also...what causes this anyhow?

It shouldnt happen for a while once you get is dissolved. Testosterone starts off as a raw powder, and the solution it is dissolved into (oil) can only hold so much powder, what has happened basically is it has fell out of the oil and start to go back to it original state. Ive only ever had this happen once and when I reheated it it never did it again, at least I used the vial up before it could.

 

[mike67]

ok..thanks for the help!

 

[Daniel_IMT_Staff]

Warming with hot water should suffice! Storing testosterone cypionate with a concentration of 200mg/ml can cause crystallization at temperatures below 68-77 degrees F.

 

[IMT staff]

cloudy and milky spells no to me, if your an IMT client call Todd he will get it replaced for you right away

IMT Rocks

 

[mike67]

ok i heated it and the crystals are gone and i dont detect any shards...but if theyre super small my weak ass eyes cant see them...suppose there were some tiny shards in the solution i missed..can it hurt me by injecting the solution in that state?

 

[aidenmanofrisque]

it crashed, dont use it

 

[hardpr]

what do you mean dont use it lol. of course you can use it. cypionate at higher mg,s tends to crash esp in the colder months. boil some water turn it off let it sit a minute place your vial in a zip lock and submerge in water for a few minutes. shake and then check it. it should be gtg.