Test P - Very painful injection site

SlimDawg

New member
I am doing a cutting cycle and using Test P 150 EOD and about 8 hours after injection, the site starts getting sore an by the next day it's super painful.

I found that applying heat to the area immediately after pin helps quite a bit with the pain, so I was wondering if it could be OK to heat the Test P before injecting, and if there are any issues with getting the temperature up there?

Thanks pros!
 
Test Prop is notorious for causing PIP (post injection pain)...

Massaging the injection site after the injection helps. Heating the oil before injecting is allright and will help push the oil through easier and it won't be as viscous when warm. I use a hairdryer for a bit.
 
I have never ever had bad pip from prop. Guess I got lucky and then I found the right recipe when I began making my own. If the concentration is 150mg/ml then you better expect pain. If it's one hundred per, that's not unusual with prop, but know there is better quality out there
 
Yeah usually when the potency is higher it means more PIP as more solvent is needed, think Test E/C compared to Test400
 
Back
Top