Test Prop First Brew - ASSISTANCE

[hons3445]

I am curently making a 10g batch of test prop. I have followed Dougoe's directions and am currently trying to melt all of the hormone. Once i applied heat the solution it began to crackle and pop abit then slowed. 95% of the powder has dissolved but there is a small amount remaining that wont seem to dissolve. I increased the heat quite abit until the solution smokes and still nothing.

I could use some advice please!

 

[hons3445]

Heres a couple pics. Only had the camera phone handy.

 

[GymLift]

• Too much heat
• Use a spoon to stir

 

[quasimodo]

• Too much heat
• Use a spoon to stir

as above, you can buy stiring rods from most suppliers for a few pence.

 

[hons3445]

Thanks guys. Is my solution still alright after over heating?

 

[GymLift]

I assume you removed it from the heat after it started to smoke?

As long as it didn't change color then you are probably ok.

 

[hons3445]

Yeah I took it off when it smoked def didn't seem right. No color change pretty light in color overall.

 

[bigpoppapump]

Microwave heats more evenly. From the center out. The stovetop heats bottom up.
But you have to be careful not to overheat.

 

[hons3445]

How long in the micro do you usually put the solution in for?

 

[bigpoppapump]

Depend on amount. And strength of Micro Usually no more than a minute and i would ck half way through.