Testosterone Prop is not clear, has "crystals" ??

[japmyers]

Hi guys

This is my third cycle of Test Prop at 300/mg week. My latest vials though are not clear, they have little "crystals" in side. I was told to heat the vials up before injection, I have done that and the product turns to its normal consistency but I wanted to post before I run it.

Has anyone heard of this? Also, can I ruin the prop by putting it in boiling water?

Thank you

 

[Wardog]

Whats the mg/mL of the prop?

Heating it shouldn't hurt it, but I would be concerned with very painful injections. I would dilute it personally. I have seen prop with crystals and usually it is because they tried to cram too much prop in.

 

[japmyers]

Hi Wardog

It's 100mg/ml.

 

[japmyers]

So I heated it up and its all cloudy now?? crap.

 

[Wardog]

How did you heat it?

 

[Biggin]

If shes cloudy, I suggest U trash it or collect it, thats just my opinion. Cloudiness isnt a good sign, at least for me it isnt.

 

[japmyers]

Hi Guys

I set it in a pot on the stove with very hot water, it did boil for a few minutes as well then I took the heat down. I read about putting it in the oven at 250 degrees as well, haven't tried that yet. I have another vial that I need to heat up as well... any suggestions as to how to do that one so I don't mess it all up

 

[THE-DET-OAK]

Is this homebrew or something?

 

[MassMonster86]

i had some local stuff like that once.. i didnt worry about it and injected it anyway.

i tried to heat it up but did nothing..

new stuff is cleaner and the most easily injectable stuff ever.

 

[japmyers]

Hi guys

Yes it's homebrew, I've used the source in the past with great results. The crystals just freaked me out, do I even need to heat it? Should i just inject it the way it is or will it hurt like hell I'm waiting on some replacements now.

Thank you all

 

[tailhold]

I wouldn't pin it. You have more on the way.

 

[japmyers]

Hi Guys

Going to toss that vial and start new The other vial never got milky... I'm thinking maybe it got moisture in it? Maybe water from boiling.. ah well. Thank you for your thoughts

 

[UglyFish]

Test Prop is not soluble in water so perhaps if water entered from boiling the test prop could precipitate.

I'd see what happens by adding more BA... or just toss it

 

[g1234]

I wouldnt run it and exchange it with another vial from my source

 

[caladin]

for shits and giggles heat in in the oven on a cookie sheet for 30mins at 250degrees. Let us know what happens. If it clears or doesnt clear. If the crystals reform when it cools.

 

[eentertainment]

Problem is you need to add more Benzyl Benzonate. Heating it will fix the problem in the short term.

 

[hogman]

Maybe it's flavor crystals!