Winstrol - Hard to inject

[itredler]

I am injecting Winstrol with 23g 1" and the last few times, the plunger would not press in once I had the needle in my butt. I had to pull it out and try a few times. A real mess.
What is going wrong?
Thanks.

 

[LivingSculpture]

23g Will inject it fine as Ive used a 25, are you making sure to SHAKE it really good b4 drawing and then going strght to injectiing, remember it is a suspension so it does seperate.

 

[Mudge]

On cloggy shots, shake up your amp, pull it, and push it as soon afterwards as possible.

Then again, why shoot Winstrol (winny) at all.

 

[jain_rahil]

I am injecting Winstrol with 23g 1" and the last few times, the plunger would not press in once I had the needle in my butt. I had to pull it out and try a few times. A real mess.
What is going wrong?
Thanks.

i had gone through same problem it solved by using 22g niddle
try to inject it as soon as possible.

 

[LivingSculpture]

hes fine with a 23, I used a 25 with Winstrol (winny), Just shake it real good and go strght to injecting.

 

[tee]

I have had that problem as well. Like was mentioned, shake the hell out of it before withdrawing it from the vial, also heating it under warm water for a minute seems to help as well.

 

[StoneColdNTO]

hes fine with a 23, I used a 25 with Winstrol (winny), Just shake it real good and go strght to injecting.

It is going to make a BIG difference if it is micronized or not.
You are correct with your statement is it is micronized, but if it's not, then you could have problems with a 21g.