A comprehensive look at modern AAS cycling by ANDY 13

LAWNSAVER

New member
If you are planning a 10 week cycle, the goal is to be at highest blood concentrations for as many of the 10 weeks as possible.

If you use a long ester such as deca at xmg/week, it will take you 4-5 weeks to build up to max blood concentrations possible for xmg/week. So half of your cycle is not wasted, but you are not maximizing efficiency.

When coming off a cycle, the waiting period before clomid therapy begins will vary depending on the type and dose of the AAS. If you ran 500mg/week of deca for 10 weeks, a month after your last shot, you will still have around 200mg of esterified deca in your system. This is more than enough to prevent recovery. This is the reason why recovery is more difficult with a deca (or another long acting ester).

Let's calculate the amount accumulated in the body after 6 weeks of 500mg/deca. Let's say you inject it once a week and we'll give it a 1.5 week half life. Note that injection frequency makes a huge difference in blood concentration stability but no difference in amount of esterified in the system

E (greek letter "sigma") 500*e^(ln(1/2)n/1.5) from n=0 to n=6. So after 6 weeks, about 1300mg of esterified nandrolone remain in the body.

Now lets see how long, after the initial injection, it takes to reduce to a small enough amount that permits recovery.

1300*e^(ln(1/2)n/1.5) After 3 weeks, 325 mg of esterified remain

after 6 weeks, 81 mg of esterified remain.

After 8 weeks, 32mg of esterified remain.


Most guys go with "time on=time off." This will not work with long esters as I have demonstrated above. For at least a month after your last shot you are in what I call a "time in-effiency" period where you are no longer reaping the benefits of you Anabolic Androgenic Steroids (AAS) but you are not recovering either. The goal of the modern cycle is to minimize this wasted time.

The key components are:
1) Front end loading this cuts down on wasted time in the beginning of your cycle waiting for the doses to reach full theraputic levels. This concept has been used before but (as far as I know) I was the first one to quantify it mathmatically. Zyg has taken the math one step further with a graph showing, visually, the importance. Graph of eq loading

The use of orals in the beginning of a cycle is a popular component of a cycle. While I don't feel it is a nessecity, it too is a (different) type of front end load. For the advnaced BBer, dbol should be taken in the beginning of a cycle as well as loading the injectables since the anabolic response from dbol is alleged to be by a different mechanism than most injectables. If one had to chose between a dbol load and and injectable load, in most cases, the injectable load should be prefered over the dbol load.

2) Injection frequency This is crucial to obtaining even blood concentrations of androgens. Ideally, the more often injected, the better. An acceptable rule of thumb is "inject at half of the half life." For instance, if the half life of a steroid is 7 days, this should be injected at least twice weekly. For cycles that involve multiple injectables, the injections should be fractioned out and divided up based on the injectable with the shortest half life. For instance, if you were doing a test propionate and deca cycle, the old school way to do it would be to inject the prop EOD and the deca once a week. Both compounds should not be viewed as separate, but together with total androgen concentration taken into consideration. If you injected the deca only once a week, probably along with one of the propionate injections, that day will have a much larger spike on total blood androgen concentrations. Instead, the deca should be split up and taken with the propionate injections, EOD. This way there is no one day of the week that has a "spike" and even blood concentrations are maintained throughout the week.

3) Ending the cycle Switching to shorter esters toward the end of a cycle makes perfect sence however not too many guys incorporate this practice- perhaps because of the lack of variety of drugs. The modern cycle should include replacing long ester injectables with shorter ones so that recovery time is made more efficient. The necesity of switching to shorter esters toward the end of a cycle depends on the type of drugs used. Longer esters such as deca and eq should be replaced with shorter acting versions of these compounds no later than four weeks before the end of a cycle. Medium length esters such as t-enanthate and cypionate should be replaced no later than three weeks before the end of a cycle. A couple examples of appropriate replacements are: trenbolone acetate and testosterone propionate. There is no need to "load" these compounds in the middle of a cycle since 1) they are already "fast acting" and 2) blood androgen concentrations are already high.

4) Recovery With the replacement of the faster acting injectables toward the end of a cycle, the "wasted" time between the end of a cycle and beginning of clomid therapy is reduced. For instance, if 100mg TA is used ED, clomid therapy may begin in as little as 5 days after the last shot. This tremendously impoves time efficiency. Clomid therapy usually last for four weeks. An excellent thread posted by The Iron Game describes this in further detail Clomid FAQ's .

When the above recomendations are made, your cycle itself is made much more efficient and if recovery time is made more efficient as well, time "off" Anabolic Androgenic Steroids (AAS) may very well be reduced so that the overall efficiency of Anabolic Androgenic Steroids (AAS) use over time is tremendously improved.


Andy
 
This is very interesting info. That I am totally going to apply to my next bulking cycle. Thanks for the article.
 
I have done some calculates,based on Andy 13 faq, and this table is result:
http://cip.prodejce.cz/deca/deca.htm

Is it right??
and if its right i gotta few questions..

I know that pure deca (nandrolon w/o ester) acting only few hours..about 4-5 ..so.. when half of injected Anabolic Androgenic Steroids (AAS) came in the blood, in case of deca is that time about 10days, this causes only short-time acting?? And after next 10days came half-half of deca,yes?...
So, this causes high concentration Anabolic Androgenic Steroids (AAS) in "half-life" days and other days what?? Fall it down...I am confused..:(
 
Last edited:
Ujo said:
I have done some calculates,based on Andy 13 faq, and this table is result:
http://cip.prodejce.cz/deca/deca.htm

Is it right??
and if its right i gotta few questions..

I know that pure deca (nandrolon w/o ester) acting only few hours..about 4-5 ..so.. when half of injected Anabolic Androgenic Steroids (AAS) came in the blood, in case of deca is that time about 10days, this causes only short-time acting?? And after next 10days came half-half of deca,yes?...
So, this causes high concentration Anabolic Androgenic Steroids (AAS) in "half-life" days and other days what?? Fall it down...I am confused..:(

AAS with esters really have TWO half lives.. The first, and only one important for injection planning, is the life of the ester.. An injection of an ester is exactly like an IV bag... The ester leaks out into the blood and is activated over time... Once the hormone is de-esterified (activated), it's blood half life is very short, like you said..

If you injected nandrolong with no ester, your blood levels would rise very fast, and then fall almost as fast..

I think Anabolic Androgenic Steroids (AAS) without esters suck.. You really have to take multiple injections in order to recieve that same stable blood levels an ester provides.

Andy
 
Stacking order to hasten post cycle recovery

Great Post. It would seem then that a stack of deca, dbol and test on a 12 week cycle would have the deca terminate after week 8 and have the dbol begin at week 8 (which is of course opposite of what I believed). Enanthate would then be used for the first 8 weeks and then switch to prop for the final 4 (or so).

Does this sound reasonable?


dbell
 
Good stuff if you want to be on and maximize gains this is a must to memorize........or have at your disposal...
 
so if i used these deca test cypio test prop. hes saying i should run it like this

test cypio 1-11
deca 1-10
prop 10-14
then start post cycle therapy (pct) 5 days later
 
Would u recommend switching from enth to prop in the 9th week of a test only first cycle?
from

imho...switching gear mid cycle is never a good idea...unless of course you have some bunk shit :)

i don't know why you would want to....by now you should be seeing some pretty mean results from enth
 
Wow that actually makes a lot of sense. Kinda flys in the face of the traditional Test E only first cycle notion, maybe its a bit complicated for a first timer? Great idea either way. The question would be though, if you're cutting say Deca down to 9 or 10 weeks, are you really getting the full potential out of the compound?
 
E (greek letter "sigma") 500*e^(ln(1/2)n/1.5) from n=0 to n=6. So after 6 weeks, about 1300mg of esterified nandrolone remain in the body.

Now lets see how long, after the initial injection, it takes to reduce to a small enough amount that permits recovery.

1300*e^(ln(1/2)n/1.5) After 3 weeks, 325 mg of esterified remain

after 6 weeks, 81 mg of esterified remain.

After 8 weeks, 32mg of esterified remain.
Does anyone know how to use the formula referenced above?
 
Superb! Generally I never read whole articles but the way you wrote this information is simply amazing and this kept my interest in reading and I enjoyed it.
nike store
Longchamp Outlet
Cheap North Face Jackets
Moncler Jackets
Longchamp Bags
Belstaff Jackets
 
Back
Top