Can you use insulin syringes to inject T Cyp?

[JOWS6]

I ran out of the regular syringes I use and went to the pharmacy to get some more. I didn't know you need a prescription for more syringes so I might not get it in time for my scheduled shot today. I have a ton of insulin syringes I used for HcG, can I use one of these or are the needles too thin? If so, what would the equivalent to 1/2mL?

 

[Bullseye Forever]

I ran out of the regular syringes I use and went to the pharmacy to get some more. I didn't know you need a prescription for more syringes so I might not get it in time for my scheduled shot today. I have a ton of insulin syringes I used for HcG, can I use one of these or are the needles too thin? If so, what would the equivalent to 1/2mL?

uuummmmm,i wouldnt think so brother....the needle may be to small for the oil.....i dont really know

 

[Misc]

if your very lean you might be able to get by doing it in your delt. heat it up so its thinner.

 

[CHIP WADOWSKI]

i ran out of the regular syringes i use and went to the pharmacy to get some more. I didn't know you need a prescription for more syringes so i might not get it in time for my scheduled shot today. I have a ton of insulin syringes i used for Human Chorionic Gonadotropin (HCG), can i use one of these or are the needles too thin? If so, what would the equivalent to 1/2ml?

actually, that seems to be what a lot of guys seem to be trying. You would backfill your slin syringe with the cyp then inject as normal.... Shoulder, quad, glute, etc. The oil will definitely take much longer to push through the pin, but it does work. As for your dosing, it depends whether you have 1/2 ml syringes or 1ml syringes. If they are 1/2 ml then you fill it all the way up. If they are 1 ml, then you fill it half way up.

 

[DJ77]

Give it a try and let us know : )

 

[GRUNT77]

It will work fine. I use to inject 80 mg a week with a BD 1/2 29 gauge needle into my delt. Very easy no pain and no problem pushing it threw because of the higher pressure. It is just slower loading.

 

[apadronjr]

u can usem juss fine, i used to be diabetic and had boxes of insulin syringes , well on my very first cycle of test I used these needles, it did take long as hell to load, but the shots to the quads and delts were a breeze, i used to take a bowl shallow enough for the vile to fit standing up without the top going under, well heat the bowl up 1.5 to 2 min, then stand the vile up in the heated water, that would thin out the oil, then load n shoot.

 

[dfeaton]

I ran out of the regular syringes I use and went to the pharmacy to get some more. I didn't know you need a prescription for more syringes so I might not get it in time for my scheduled shot today. I have a ton of insulin syringes I used for HcG, can I use one of these or are the needles too thin? If so, what would the equivalent to 1/2mL?

Not sure if you could draw from a vial, but I back fill the slim pins & inject into my shoulders all the time.

 

[MoparMuscle]

actually, that seems to be what a lot of guys seem to be trying. You would backfill your slin syringe with the cyp then inject as normal.... Shoulder, quad, glute, etc. The oil will definitely take much longer to push through the pin, but it does work. As for your dosing, it depends whether you have 1/2 ml syringes or 1ml syringes. If they are 1/2 ml then you fill it all the way up. If they are 1 ml, then you fill it half way up.

Use 29g 1cc 1/2" slin pin and backfill (careful to be clean). It goes just as fast as a 23g inject wise.

Inject in areas with less fat intermuscle. I do traps, pecks, tri, bi, shoulders, calves and legs (I'm lean all over). I also dimple the skin a bit to get it deeper.

 

[JOWS6]

What does "backfilling the syringe" mean?

 

[MoparMuscle]

Draw like normal from vial with 3cc 1" 23g pin, pull stopper out of slin pin, inject oil from 3cc 23g pin into back of slin pin (back load). Put stopper back in, tap air to top and push out, swap area to inject. Inject intermuscle (full 1/2" with some dimple in skin).

 

[DJ77]

Nice! I'm gonna try that

 

[MoparMuscle]

Wash your hands good, touch just the back of the slin pin plunger and don't breath on the slin pin back while your doing it. iMO this extra step adds risk for infection but if you wash, swab good and are careful it should be fine. I love it. Did my testosterone replacement therapy (TRT) into my right bi today.

 

[Misc]

its easier if you have changeable needles for your slin pins, no back loading

 

[MoparMuscle]

its easier if you have changeable needles for your slin pins, no back loading

I'd see no issue with injecting with the same pin used to draw, a slightly blunted 29g is still gonna be smooth. Like Human Chorionic Gonadotropin (HCG), I use the same slin pin to draw and pin with with no issues. With a bigger gauge like a 23g you swap pins because a blunted 23g will result in more tissue damage over time.

The main issue is it would take a long ass time to suck a ml though a 29g pin (several min maybe), in fact I doubt there is enough presure to even suck a full ML, I have never tried so someone correct this If its wrong.

 

[username1]

I also dimple the skin a bit to get it deeper.

what does it mean to "dimple" the skin? how do you do that?

 

[Tibudo]

I draw with a 23g and use a 27g to pin my test c. It's a slow process, but no pain at all.

 

[cashout]

I used a 23 g 1.5 inch to draw and a 31 g 5/16 inch to shoot delts for a year and a half.

Takes all of 30 seconds and there is no pain whatsoever. I would never shoot any other way.

I hated stabbing a 23 g or 25 g into my glute - not comfortable especially if one is injecting more frequently than once a week.

 

[DaHurt]

Actually just tried injecting my delt with a 29g insulin syringe (test e) a few days ago for the first time. Heated the oil and back-filled the syringe, then injected. Smooth as butter...I'm a fan!

 

[corvettels3]

Actually just tried injecting my delt with a 29g insulin syringe (test e) a few days ago for the first time. Heated the oil and back-filled the syringe, then injected. Smooth as butter...I'm a fan!

How long did it to inject? I always shoot with a 23 in the quad. It takes about 5 seconds.