deca turned into milk lol, powder wet

[Rozyzz]

Hi fellas, i new in the homebrew , i make test enan and deca .(200mg/ml)
But the deca when I cooked was transparent, and after filtering and cooling was white.
the powder is a bit sticky, wet and my supplier says that the normal

i follow the recipe
bb18 %
ba2 %
and sunflower oil
View attachment 557858

 

[Buttman3]

...

 

[Buttman3]

Hi mate,

To make it transparent, you need to

1. Heat again at 35 Celsius (melting point) for 5-10 minutes or until the milk color disappear.

2. Swirl the vial to ensure all is dissolved evenly.

3. If needed, heat again at 35 Celsius until you see nothing.

When you heat, place a pin on the vial to release pressure:

 

[Rastas]

Some testosterone tends to go a little waxy. I'm not sure why it went that colour once filtered. It appears to have crashed. Buttman is always right so follow his instructions.

 

[Rozyzz]

I did this process 2 times, when it gets hot and translucent, so back to room temperature 25 ~ 30 c is this white
in will change the recipe less BB %2ba/%10bb, for 200 or 250 mg/ml

 

[Buttman3]

I did this process 2 times, when it gets hot and translucent, so back to room temperature 25 ~ 30 c is this white
in will change the recipe less BB %2ba/%10bb, for 200 or 250 mg/ml

If you heat it a few more times, I think it will eventually remain translucent at room temperature.

I have done this with Stanozolol, and I had to heat it several times to get it to remain translucent.

 

[Rastas]

You shouldn't need to, but you COULD look at adding guaiacol if it really won't remain stable and refiltering. Personally, I'd throw it out and start again.