gear started pouring out dont know whats wrong

[popeye19]

heyy guys this is my second cycle and this morning i injected in the same delt that i injected last monday. but after the gear was in my shoulder i pulled the syringe out and the gear that was is in my shoulder started pouring back out from my delt.

Do you guys think there was two much gear in the delt i only put 1cc. and 1cc last monday in that same delt. so im just curious.
would someone just help me out on this question thanks

 

[mike4563]

I was reading about something called z tracking the other day, it is basically a technique used to stop what's gone in coming out.

I'm not to sure if it would work on the delt tho, as I think used more in the larger muscles. See the link below

Z-Track Injection: Encyclopedia of Nursing & Allied Health

 

[Mudge]

How deep are you shooting? I've had a few 'drops' come out, none more, it can happen.

 

[joeyh1991]

i had that happen to me when i first started and i use a inch in a half pin and it still came out after goin all the way in. i was told to inject it a little slower and dont pull out right away after you inject give it a sec to absorb in the muscle. that helped me!

 

[coltmc45]

Inject slower and leave the pin in after your done for about 30 seconds. Make sure you're injecting deep enough.

 

[joeyh1991]

Inject slower and leave the pin in after your done for about 30 seconds. Make sure you're injecting deep enough.

^^^^

 

[barrysanders]

Its a common problem. I have it happen every once in a while (not quite pouring out like you mentioned but a few drops). Everyones right who said go slower with your pin..take your time. It usually will take be about 1 minute to pin 1.5 cc. Afterwards make sure your rubbing the pin spot hard to help the juice spread evenly. Also, take a look at your BF and distinguish what size needle that you need. I'm pretty lean so I can use 5/8 for almost everything other than glutes..which i use 1"

 

[tommygunn76]

My Gf just learned in nurseing school ( she gives my shots) That for every cc,it shouldtake you 10 sec to inject. So if your doing 2 cc's then it should take you up to 20 sec's to do the whole injection once you start the push on the syringe. Maybe your pushing it to fast and it isnt havin enough time to spead its self out

 

[Shovel]

Stop pinning the same spot over and over... If you put an air bubble behind the oil it'll keep the oil in. Also gets all the oil out of the pin, wastes none that way.

 

[Misc]

.

 

[popeye19]

okk thnks for your guys help i will try to do it a little slower. Because i usually try to get it over as fast as possible. so thats probably the problem. i will try it your guys way mon when i inject again thnks