Heating syringe!?!

[Phil Mc Win]

Hey guys, need to know how hot the water can be for heating up the oil in a syringe. Im using test 400 and its so fuckin thick. Can i use boiling water? or would thatmelt the plastic. I want it as hot as it can be now. No more playing arround with this. I can barely push it is is how viscous it is.


Thanks.

 

[MeatHead96]

I use a blow dryer on the syringe for 30 seconds or so before inject.

 

[UserAt204]

No boiling water will melt the syringe. Turn that faucet on hot and warm it with that. Don't let water run over the needle or cap.

Hair dryer is probably easier. I personally don't heat mine and use a 29g slin pin for injects so I don't see how you guys all have trouble.

 

[Natehayes]

I find it easier to heat the vial. Just pop it in a small cup of hot water, let it sit for a couple of minutes and then draw nice, warm, thin gear.

 

[Natehayes]

No boiling water will melt the syringe. Turn that faucet on hot and warm it with that. Don't let water run over the needle or cap.

Hair dryer is probably easier. I personally don't heat mine and use a 29g slin pin for injects so I don't see how you guys all have trouble.

I like the slin pins too. I've been using them for a couple of years for TRT.

 

[Cobra Strike]

I think all this heating shit is a waste of time....dont people have thumbs anymore?

 

[harimau]

I agree submerge the vial in warm water but only up to point of were there fluid is. Also you can get a bigger gauge needle for drawing for t-400 I use a 14-16g.

 

[jswole]

You might want to add in thumb presses during your workout

 

[China_Wall]

just man up and inject with a 22 gauge... no problem at all... I'm in agreement that heatin up the stuff is not needed at all

 

[methos]

How can come of you use slin pins? Do you inject areas with very thin skin? Or are you not concerned about getting the juice in the muscle? 23 gauge works for me and I can't even feel it going in. I am curious about the slin pins since I have so much scar tissue built up.

 

[timbo357]

boiling water wont melt the plastic if your seriously having that much trouble any of these tips will work

 

[TehRage]

Are yours all pre-loaded? I've found that using a heatgun/blowdryer to warm up the vial for the oil based compounds helps out a LOT. The plunger still moves much slower than it does with a water based compound, but it helps.

 

[MeatHead96]

How can come of you use slin pins? Do you inject areas with very thin skin? Or are you not concerned about getting the juice in the muscle? 23 gauge works for me and I can't even feel it going in. I am curious about the slin pins since I have so much scar tissue built up.

I inject in delts and traps with slin pins. It works just fine in lean areas. Bloodwork proves it. Less scar tissue build up and painless injections.