Home brewed gear...One question

[nyc]

I just home brewed some gear last week. I made 150ml's of tren 75mg/ml and 120ml's of test enan 250mg/ml. The tren came out great. My question is about the test. After i finished the conversion i noticed that while the bottles are at rest they look fine, when i give them a shake you can see "waves" appear, like the hormone and oil are seperating. I was wondering if i should reheat them and shake them up or something to get it to mix better? I posted this in the chemical forum but didnt get much help there. Here is the link to that post which has a pic of the gear i made. http://steroidology.com/forum/showthread.php?s=&threadid=35747 Thanks for any help or advice.


NYC

 

[InsuranceMan]

Did you try posting this over in the chemical study forum? One of those guru's should be able to help you out.

 

[clee]

NYC [/B][/QUOTE] I posted this in the chemical forum but didnt get much help there

Insurance Man; good question! Did you read the post?

 

[InsuranceMan]

My bad, bro. I was too busy looking at the pics.

 

[Vennom96]

I had a similar problem. Stick a 23 or 25G needle in the vial and bake it in the oven for about 30 min on 275. Cleared mine right up.

 

[nyc]

I had a similar problem. Stick a 23 or 25G needle in the vial and bake it in the oven for about 30 min on 275. Cleared mine right up.

Thanks everyone. I'll give that a shot tomorrow.