same ratio for tren e as test e?

[Bimmer]

Since both are enanthate esters can I use the same ratios? Iv made test cyp before but not enanthate, and never touched tren.

 

[BigRonWannabee]

No. Very different hormones, regardless of ester the solvents need to be changed up. Cyp & and tren E can go with similar solvents while test E needs none if you choose.

What I did...
2/15 for tren E

What Id do...
1/20 or 2/20

Heres my little contribution to IA's board...

Trenbolone Enanthate, Testosterone Cypionate
These raw hormones are not soluable in oil alone (at STP). Though they have relatively long esters, they will need additional solvents. We will use BA as an antimicrobial and BB as our cosolvent.

Items Needed for a 10 gram conversion:

• 10 grams Testosterone Cypionate or Tren Enanthate
• 0.80ml benzyl alcohol (2% BA)
• 8.00ml benzyl benzoate (20% BB)
• 23.20ml oil
• Syringes 3cc & 5cc or 10cc
• 20 gauge needles
• Mixing vial (or preferably beaker)
• Sterile vial
• Sterile syringe filter

1. Weigh out 10 grams of hormone into mixing vial or beaker.
2. Add benzyl alcohol and 18.2cc of oil. (This will leave 5cc oil for later.)
3. Place on stovetop (electric stove) or frying pan (gas stove) on medium high heat.
4. Swirl and heat until soultion is completely homogeneous and clear. NO hormone "swirls" , crystals, or visible separation should be left.
5. Place 20g needle in sterile vial and attach syringe filter.
6. Place another needle through stopper to releave pressure
7. Draw out hormone solution with 5 or 10cc syringe and run it through the syringe filter until all solution is filtered.
8. Run the addition 5cc of saved oil from step 2 through syringe filter to purge.

This conversion results in 40ml - 250mg/ml sterile solution for injection.

 

[Bimmer]

nice sticky on the top of the page!