Whats wrong with my prop? Has crystals in it, is this ok?

[va703]

I got my gp prop from a trusted suplier. 2 of the 3 10ml vials have Crystals that float around in it, it almost looks like clear plastic pieces in it, what is this and is it ok? will it affect the strength. I imagine the needle wont suck the pieces up, but if so will it be ok to pin?

 

[gorillaglue]

The crystals are steroid that has crashed. If you manage to draw up and inject a crystal with your oil, get ready for some pain (don't do it). If you start injecting any of it before getting the crystals back in solution (if you can-depends on how bad it is-google or search for how to uncrash gear) or getting some replacement gear (try that first), then yes, you will affect the potency b/c part of that 100mg/ml test prop is sitting in those crystals right now, so the liquid is proportionately less potent.

 

[builttuff32]

warm the vials up before withdrawing and it should reform. Right now its crashed, prolly from cold weather.

 

[kev ute]

I had this problem with some cyp a few months back. Until i could get it replaced, i would heat it up either in warm water or by sitting on the vial. Though even this didn't fully get those plastic looking floaties to go away. So i still used it for about 2 more shots till my replacement came.

And i definately think that coldness caused the problem for mine. Mine was being stored in a pretty cool room and then the problem began.

 

[Mudge]

Prop can crash without plenty of BB, I've had to go into the 24% range with my own on one batch. You may have to rebake 275-300F depending how much is crashed, I pull mine out every 10 minutes and shake, took 25 minutes for my last batch to stay suspended @ 300F, been holding fine since.