Need some advice pinning.

[G-cortese]

Hey guys,

I would appreciate if someone would give me some advice on how to draw my oil properly... I only have access to 25G needles, and am struggling to draw 1ml of my blend which is 100mg of test, tren and mast each. when i pull back to draw oil i get resistance and a bubbly noise, then literally no gear comes in, am I just being impatient with drawing? since its such a fine needle?

I did manage to inject fine just struggled on the drawing part, am I being too impatient?

 

[cheechjp]

Have you tired drawing in air into the syringe before injecting the vial and then pump the air in to the vial to create a back pressure when drawing?

 

[fancyhuh101]

^^^ most people use a much larger needle to draw thick oils with , i use a 18G to draw and 25G to inject .trying to draw with 25G is a natural pain in the ass so its normal , if u dont have a biger needle to draw with ur just going to have to be patient , draw air into the syringe , if u are taking 1ml of oil , draw 1ml of air into the syringe and push it into the vial before u try drawing , this will create pressure that helps puh the oil out easier

 

[Tailchaser]

^^^ most people use a much larger needle to draw thick oils with , i use a 18G to draw and 25G to inject .trying to draw with 25G is a natural pain in the ass so its normal , if u dont have a biger needle to draw with ur just going to have to be patient , draw air into the syringe , if u are taking 1ml of oil , draw 1ml of air into the syringe and push it into the vial before u try drawing , this will create pressure that helps puh the oil out easier

Exactly what he said^^^^^

 

[halfwit]

Have you tired drawing in air into the syringe before injecting the vial and then pump the air in to the vial to create a back pressure when drawing?

Lol, before we talk about needle sizes I think ^ this should be looked at first. Trying to remove a liquid from an air-sealed container creates a vacuum, that's why you're supposed to inject the same quantity of air that you're about to remove from the vial.

 

[G-cortese]

Thanks for the responses, i tried to inject air at every attempt, i dont think i was patient enough and should have heated up the oil to mate it easier.

 

[SolomonGrundy]

inject equal amount of air that you plan to withdraw, tilt vile sideways, wait cause it takes like 2 or 3 min to fill, I let it sit so the fine air bubbles disparate . its easiest to have a 18g or something else to draw with but most pharmacies are bitches about providing this, they assume you're sharing your meds ;-( , but online works

 

[whitelml]

I use a 18g to draw and a 23g to inject. Keep an eye on the 18 so it doesn't take a piece of rubber with it when putting in vial. It's a big ass needle