How should this be handled, the gear i got was from a buddy(close buddy) and feel fucked right now. I just did my 8th injection of 1ml of 250 test e, and there is no more in the bottle. I can read well and can distinguish numbers well, and the bottle says 10 ml, I drew out exactly 1 ml each time and now I am 2 ml short! What would be politically correct in bringing this up or is it just my loss? Is there a way to draw out my other bottles and replace them without contaminating the gear, I just want to know if my other bottles are short too.
only 8 ml in my 10 ml bottle?
- Thread starter 1Tenacity
- Start date
E
estray
Guest
Ive had that happen a few times. Usually its 1ml short. Part of it is waste in the syringe.
windshield
Deadlift Whore
good friend or not, sounds like he needs an ass whippin.
P
PARKER27
Guest
You'd have to be pretty careless to lose 500mgs of Test do to injection waste.
Who knows though, not injecting properly can lead to a loss of the injected compound. Make sure you leave the pin in the injection site for about 10 seconds after the plunger is tapped, this allows what's left to not only get out, but to disburse properly throughout the site.
Who knows though, not injecting properly can lead to a loss of the injected compound. Make sure you leave the pin in the injection site for about 10 seconds after the plunger is tapped, this allows what's left to not only get out, but to disburse properly throughout the site.
T
Thoms
Guest
In order to complete your planned cycle, you'll be forced to open another bottle, that's forsure. I don't see where contamination comes into play. As for the other bottles, you can simply compare if they are all filled the same.
I
ironfreak703
Guest
yep i wouldnt b upset at ur dude. he got u good gear. i always get an extra bottle cuz this is bound to happen. u do lose a little bit in the end of the needle. it happens to everyone. 2cc is alot but if they are all filled the same just be more carefull how much u draw out.
TheMilkMan
New member
iv'e never lost more than about .5ml out of a bottle, but i also draw up about .3cc's of air and shoot that too, to make sure i'm not wasting anything...
i know alot of you guys are going to say thats a bad idea, but i was actually advised by a dr. that there is not problem in doing that, your muscles can take 3+ cc's of air without much of a problem
i know alot of you guys are going to say thats a bad idea, but i was actually advised by a dr. that there is not problem in doing that, your muscles can take 3+ cc's of air without much of a problem
I
ironfreak703
Guest
or if ur alex kick his ass. lol
I
ironfreak703
Guest
my chick is a nurse and air is bad in a needle. could b wrong but i dont chance it. NO AIR!!!. not knockin u cow but its just what i have been tought
TheMilkMan
New member
ironfreak703 said:
when it comes to IV injections, yes...
but when it comes to IM injections, from what i understand, NO
if someone knows better, then let me know
DocJ???
E
estray
Guest
MilkDaScow said:
exactly. But its important to aspirate if youre gonna do it like that.
I
ironfreak703
Guest
still i will just stick with what i know. no air bubbles on my part. personal preffrence. u really put air in every shot?? scares the shit out of me
Similar threads
