Painful post injection!

^^^ alright thanks !!!! I guess i will just go by trail and error like you said. I just didnt want to quit this cycle over pip. I mean i have researched to hard to quit a cycle over this, but if it keeps on i might have to. I dont think i will have to quit it though like you said C Wood it should not hurt as bad as time goes on. Hopefully since am doing my glutes it want hurt as bad . Since there is more room to inject there and its a larger muscle. If it does hurt as bad as my quads and delts though its going to suck i wouldn't be able to lay down or sit down. "crossing fingers"
 
Not much to add, but I use a 1" 23ga needle and inject in my quads. No problem and no worries about the needle length.
 
One inch is one inch, regardless of gauge. 1", for me, gets it deep enough. The hole you're pushing it though just determines how much effort is needed to get it in there.
 
i would listen to some of the others and try cutting it with oil again, i had similiar problem as you, got new gear and now no pain. inject techniqe and inject spots did not change, but the pain is no more. definately the gear. my originial was from uncle and the replacement was also from uncle. the second one was different packiging and looked more legit, i told him about the pain and he sent a replacement. i would recommend talkin' to z, he made good with me....
 
ok i know this is off subject but i figured i would ask. Its prolly a studied question but its better to ask. Ok i notice tonight that when i have the vial upside down and i pull the plunger back into 1cc goes into the syringe it looks like it measure perfectly 1cc but when i flip it back over it dont even look no where near 1cc?
 
ok i know this is off subject but i figured i would ask. Its prolly a studied question but its better to ask. Ok i notice tonight that when i have the vial upside down and i pull the plunger back into 1cc goes into the syringe it looks like it measure perfectly 1cc but when i flip it back over it dont even look no where near 1cc?

You need to push a half cc of air into the vial before pulling.
 
^^ya i do that. Ok i wanted to ask another question my shoulder soreness is finally starting to go away. The thing is though its red swollen and its not really hot but the redness has spread down to the middle of my bicep and when i push my finger onto my shoulder real hard it kinda makes a little indention, but not bad. It also itches sometimes and stings every once in awhile.No lumps are knots either you cant even tell where i injected it. I know what this sounds like but my leg did this same thing and its fine now. So i dont know what could be doing this?
 
Last edited:
the indent u described after pushin on it is subq edema (water in the tissue), secondary to the inflammation you had earlier, it will clear as the body absorbs it. my arm was like double the size after the shot, looked hella swole, but too bad i could barely move it. did u try cutting it with oil??
 
I wouldn't cut it IMO, you'll get used to it. Its not like your pinning test400.

like wood said I'm still trying to find the sweet spot. I have no pain when pin glutes, but do with quads. So gonna try to find a better spot and see how it goes
 
Last edited:
Well i got some good news talked to Z and told him about the pain and stuff and he is going to send me replacements!!!! (so hopefully these will be better,maybe he might cut it with alittle extra oil or cut the BA down) Dang Z is awesome ! I dont know of anyone else that would do this.
 
Hey

Remeber guys

this staff realy have 300mg/ml and if you shot 1.5cc or 2 cc this is high dosage, and you fell big painful

z.
 
Back
Top