insaned said:what was the concentration? I can handle 100mg/ml without any probs...
altough I've could tried higher than this because the filtration process becomes a problem.
The pain is usually from the gear concentration or/and tolerance to pain. Some guys can have painless injections from concentrated gear while other don't!
but...what do you mean by the particles beeing very big?
You mean it was granular? ...not fine like baby powder? I don't think that's winstrol then...but then again Winstrol (winny) is an uncomfortable inject for many people compared to other compounds.CILENTINO said:I mean that when i received my powder from Ukrainia it looked like diet sugar, ti was not a thin powder... the krystals were big.
thalsa_doom said:icant filter stanozolol, but can be for that , i only have bottle top filter of 22 um, is totally needed 45 um?
i dont know how yoy can make....insaned said:I run trough a 22um for 100mg/ml.
Cilentino, post a pic! It's easier that way.
What concentration did you made it afterall?
DocJ said:You mean it was granular? ...not fine like baby powder? I don't think that's winstrol then...but then again Winstrol (winny) is an uncomfortable inject for many people compared to other compounds.
Seemed wet? Take a picture and post it on here if you can.CILENTINO said:Yes it was a little bit granular and seemed wet. I have a new batch from china that is much more thiner. I made a 50mg/ml, i'am not a pussy but it was insuportable a the pain last fot one week.
yeah, i disolve it, but after my fliter unit dont work!!!!insaned said:wet powder is far from winstrol... does it melt on hand?
thalsa doom.. didn't understood well how you do it...
You just need to dissolve the Winstrol (winny) in the PEG and ps80 with good heat since it has high MP, and then filter it to a vial that already contains the water.
insaned said:wet powder is far from winstrol... does it melt on hand?
thalsa doom.. didn't understood well how you do it...
You just need to dissolve the Winstrol (winny) in the PEG and ps80 with good heat since it has high MP, and then filter it to a vial that already contains the water.
thanks insaned, but i use bottle top filters, can be keep warm probabilly.insaned said:you just filter at a temp that woun't destroy the filter membrane! not too hot, not too cold is your best shot! If you can hold the syringe with the solution without beeing too hot, probably is good to go.
cilentino.. a pic would value a lot.. that way it's hard to know, but that seems a strange stano in normal conditions.
thalsa_doom said:one more time, today i had maked stano, and i was cant filter!!!!
the next time i¡ll try to filter more hot...
hola douro, estoy usando filtros top bottle que son una delicia para todo, pero el Winstrol (winny) no puedo.....Douro said:are you using a dry filter?
btw, i understand spanish...