Prop at 150mg/mL

[Amateur]

Has anyone made prop at 150mg/mL?

I did a search but didn't come up with anything is there any reason why it's standard at 100mg/mL? would 150mg be too painful?

Thanks

 

[GymLift]

Seems like there was a thread about 200mg/mL recently.

 

[crushershockey]

my source makes his at 200mg/ml now... uses EO for painless shots

 

[DocJ]

It's a matter of the final product "holding" at 150mg/ml, it most likely won't. I've made 125mg/ml with the traditional 2/20 BA/BB and it held but I'm guessing barely. Ethyl oleate will allow you to make 200mg/ml easily with propionate or phenylpropionate esters.

 

[Amateur]

can anyone point me in the direction of ordering some EO? And what would be instructions for making it. Instead of using 100% oil I'd use 50/50 along with 2/20 BA/BB?

 

[Hellcat]

@DocJ
Did you made 200mg Testo-P with EO and it helds? What was the mixture of solvents?

 

[Amateur]

And with the EO does it just completely replace the oil or is it a mixture like 50/50?

 

[DocJ]

http://www.lemelange.com/body_builder_supplies.htm

200mg/ml TProp: 2%BA, 20%BB, EO as the carrier oil ONLY.

 

[Amateur]

I see some people use 50% oil 50% EO is there any reason for this? Is EO very similar to oil?

 

[DocJ]

I see some people use 50% oil 50% EO is there any reason for this? Is EO very similar to oil?

Yes it basically oil-like. 50/50 with another oil like grapeseed seems eliminate the pain factor for 50-100mg/ml prop but if you want a high concentration that's painless (150mg/ml+) then I'd do 100% EO.

 

[Amateur]

Ok thanks I'll be trying 200mg/mL in the next couple of months so i'll post up how it goes.