Solid Test C?

[A.Dick]

Hey there,

First time poster, long time reader.

I just got some Medistar Test C and one of the vials came frozen solid, I ran it under hot water and thawed it out. I was unable to get it completely thawed, there were still cloudy crystals in suspended in the liquid. The other vial appears completely fine and good to go. Both from the same batch too.View attachment 548543View attachment 548544View attachment 548545View attachment 548546
The supplier feels it should be fine to use, it would mean warming it up for a half hour every time I was going to dose. Even then there's the cloudy crystals floating about that have me skeptical.

Appreciate any thoughts/comments.

 

[cause4alarm]

At least you know that lab is putting actual test cyp in their gear!

This is extremely common with cyp, especially in the winter months. To allow the crystals to dissolve back into the oil, put a needle through the rubber stopper but not too deep where it's close to the oil (the oil will expand and rise in the vial with heat and it can come out the needle wasting the gear) and put it in your oven set on 200F for about 10 mins. If its still not fully dissolved, take the needle out of the vial, shake it up for a bit and redo the process for another 5-10 mins.

I've had some bottles that baking it one time will do it, while others I had to bake every time before an injection.

 

[unknown21]

I have a cloudy vial also. Its test c. Its was from pinnacle. its fuller than 10ml always. im guessing water go into it from being cold or something idk. but would it still be safe to pin? I have reheated it like 3 times and goes away for like 10mins then goes back to cloundy.

 

[ridgeback]

My AML Test 400 did this last week, I got an old empty bottle of Prop and opened a new prop and put 2 ml's into the old empty bottle, then drew down 2 ml's of Tren Ace and added that to the old prop bottle, i then melted back my crashed T400 and drew down 4 ml's of that and added it to the old prop bottle, solution is still good and i have a new prop - tren - t 400 blend!!

Now it is 175 mg cyp
175 mg's test Enanthate
100 mg's Prop
50 mg's Tren Ace

all in 1.5 ml's!!!

No more crashed test!!