test e {250} homebrew

[harleyman]

getting ready to brew up some test e 20 grams need a little help on bb% 15 0r 20 going 3%ba thanks

 

[BigRonWannabee]

test E will go into solution pretty easily with a little heat, no solvents needed. Add 2% BA to keep it sterile, and add whatever %bb you want...you do NOT need it at all but it can thin your batch out a bit, which I find to be a plus with high mg/ml gear. If you want a tad thinner brew, use 20%bb imo.

 

[pullinbig]

or use thinner oil and skip the bb.

 

[harleyman]

thanks going to try 2% and 12% bb.

 

[Eze]

I made some 250mg Test Enan and all I used was 1%BA just for peace of mind.

There is no need for so much solvent

 

[pullinbig]

bb is not gonna hurt at all. doug uses it to thin the final solution. bb could prolly be used as a carrier much like peg. i like using thiner oil. until a year or so ago i didnt use ba in T enan, deca or eq. just oil and filter. i had one batch of eq that took me over 2 years to do with no ba in it and never had a prob. 400mg/ml.

 

[JohnnyB]

Damn, some guys get cellulites from multi dose Winstrol (winny) because it doesn't have BA in it.

JohnnyB

 

[pullinbig]

bac water has BA in it. i have never heard of Winstrol (winny) that was ba free. its part of the normal manufactoring procedure to make all injectables that are water based along with autoclaving.

you have to remeber that ba dont sterilize a solution, its a preservative (antimicrobial). filtering and heat does. but with water based products the entire solution cant be filtered at once. the water can be and then the hormone/solvent solution can be.