What causes site injection soreness?

[OLYMPIAN]

Mind you Im not talking at the exact spot of where the needle enters. I understand brusing etc., but moreso muscle soreness 4, 5, or even 6 inches from the needle entry point 3-4 days later.

For instance, I did a quad injection of Test e. Slight needle pinch at the site, but other than that, painless.

Then about 2-3 days later, my quad gets sore as hell and it seems as if the gear "dripped" down my leg as I felt sore almost down to my knee.

Is this normal? Adverse reaction? Is it receptor response soreness or something? My leg is fine now, but all my shots seem to go the same way with disapated soreness around the injection site.

In short, I guess my question is if gear uptake by the receptors usually results in soreness and why?

 

[Ythrashin]

Are you still pinning in the center of your quad toward the bottom or middle?

Pin high to the outside...

I never have that happen.

The soreness is virgin muscles, location and they dont like the BA in the juice. Mix your juice with some B12 and adjust your entry point. It may help...

Is it kicking in yet? It should be....

 

[Big Ron 29]

Quad Injection

I have a question concerning quad injection. I'm on my third cycle over the last 5 years but never injected to my quads until this cycle of Tren and Test Enan. I hit my right quad no prob but when I tried my left quad I had a little problem.

I went in about mid quad and to the outside of the muscle. As soon as I broke the skin I saw and felt my muscle flinch... I tried to push in a litle further and again felt the muscle twitch. I pulled out the pin, little bit of blood and and immediate small purple lump. Lump went away over the next couple hours and over the next couple of days the area around the injection turned light purple then light green. There is no pain, so soreness and it is slowly going away. I'm not worried about it being a problem but just wondering what I did wrong.

Did I hit a nerve, blood vessel, maye just a bad spot on the quad?

Thanks

 

[TheMilkMan]

OLYMPIAN...

Site soreness can come from a number of things:

High hormone concentration
High BA content
High solvent content
Virgin muscles
Large injection volume
Moving the needle too much when it was in the site
Body's adverse reaction to the gear

Just to name a few... What lab are you running?

 

[3J]

if i understand correctly the ester absorbs faster then the test, leaving the test to crystalize on your muscle which causes stiff soreness...

also milkman made some great points.. it can also be refered pain

 

[Big Ron 29]

Site Injection

Yes, it was my first injection to my left quad but on that day it was only 50mg of Tren and it is Australla Vet.

I have hit the shoulders previously on this cycle with no issue even with 50mg Tren and 200mg Test Enan.

Just to clarify, I did not inject after the muscle twitched twice, I pulled it out and used the shoulder again with no problem.

 

[3J]

Yes, it was my first injection to my left quad but on that day it was only 50mg of Tren and it is Australla Vet.

I have hit the shoulders previously on this cycle with no issue even with 50mg Tren and 200mg Test Enan.

Just to clarify, I did not inject after the muscle twitched twice, I pulled it out and used the shoulder again with no problem.

sounds like virgin muscle to me.... tough it out bud...

 

[Big Ron 29]

Site Injection

Ha ha, thanks Jam. I dont have any pain or soreness. I just wanted to know if I hit the muscle wrong and how I should adjust my next injection. I hit the same spot as I did on my right quad and now I'm reluctant to try the left quad again.

 

[3J]

Ha ha, thanks Jam. I dont have any pain or soreness. I just wanted to know if I hit the muscle wrong and how I should adjust my next injection. I hit the same spot as I did on my right quad and now I'm reluctant to try the left quad again.

welcome to pinning... everyones body is diff... it's trail and error..

i know exactly where to pin so i dont go through a vein or a nerve or such..

yet i have hit both in the past...

iv also never had issues with my shoulders... but the fluid always backs out of it.. so i like using my thighs..

 

[Big Ron 29]

Milkman... can you clarify "high ba content" and "high solvent"

Not sure what your referring to and how I can adjust these for future injections.

Thanks

 

[THE-DET-OAK]

BA = Benzyl Alcohol

solvent = BB= Benzyl Benzoate

 

[THE-DET-OAK]

you can not adjust those-get some B12 to mix with your injections-or maybe even a lil Ethyl Oleate to thin it out

 

[OLYMPIAN]

Are you still pinning in the center of your quad toward the bottom or middle?

Pin high to the outside...

I never have that happen.

The soreness is virgin muscles, location and they dont like the BA in the juice. Mix your juice with some B12 and adjust your entry point. It may help...

Is it kicking in yet? It should be....

We'll Ive never pinned the center if you will. Its been middle/high and on the outside.

Doesnt matter though. I cycle quads, glutes and delts and it happens no matter where I pin, so Its not the location.

And no, the shit still isnt kicking in, and if it has, its so mild that I really dont notice. I made another thread about upping my dose for the 2nd half of the cycle but didnt really get any responses.

I think Im just going to strap an oil drum to my back full of gear and run a garden hose from it to the back of my neck and go all BANE status.

Six weeks in and still "waiting"....