Is pinning 2cc at once too much
- Thread starter jeffbmx
- Start date
Powerstroke32
New member
2cc is fine in the thigh and glutes, I prefer the thigh because I can self inject and don't have to worry about anything. I wouldn't recommend 2cc in the delt or any other site. I'm not sure on mixing the two, but shouldn't be an issue.
what you've proposed is ok
mixing is fine and any muscle should be able to handle 2cc
mixing is fine and any muscle should be able to handle 2cc
THE-ORACLE
IRON DEMON
of course its ok...im up all the way with 3 ml on my shots it takes a facking long time to push but yeah its up there...sepends on what your pinning
Powerstroke32
New member
depending on the size on the injectee wouldn't it? sticking a 1in needle in my delt just trips me out lol. I feel safer and less paranoid self injection in a muscle I'm positive can handle the needle and dosage, such as thighs. I don't like glutes because I feel I don't get the full intramuscular injection unless I use a 1.5in and even then I don't like letting others inject.
Live2Train
New member
When shooting in the penis I only go 1 ml at a time. I think any more may be a little excessive.
g1234
Shut up and squat !
depends on the penis
ozzy can handle 5ml no problem
jeffbmx what you suggest is good, just don't forget to rotate injection sites, check this www.spotinjections.com
ozzy can handle 5ml no problem
jeffbmx what you suggest is good, just don't forget to rotate injection sites, check this www.spotinjections.com
Last edited:
Ozzy27
Olympian Bodybuilder
What are ya kidding? I'm hung like a light switch , might be hard to fit 1/2ml in there. lmao
Ok...back to topic........
K
Kane_Red_Machine
Guest
both at the same time is ok.
I am using a 23G x 1" 3ml syringe to pin, the oils are fairly thick, when I draw them I push in 1ml of air, then flip the vial upside down a begin to draw 1ml oil, when drawing the oil I am getting tonnes of tiny air bubbles and the oil is very slow filling. It eventually fills into the syringe but takes quite a few flicks to get rid of the bubbles.
Do I have to use a larger guage syringe for pinning?
Is it ok to warm the vials a bit with a hair dryer for the oils to move better?
Do I have to use a larger guage syringe for pinning?
Is it ok to warm the vials a bit with a hair dryer for the oils to move better?
K
Kane_Red_Machine
Guest
yes 21 is better.
i prepare my seringue for inject the evening before, you will see, the tiny bubbles wil come at onle bigger, and then it's easy to push it outside.
i never warmed a vial. but my medecinchest is a dry place always at 8°.
when i prepare my seringue i let it one night in my medecine-set.
that way any carrier of oil will mix without prob. and also, i've notified than my injec are smoother.
i prepare my seringue for inject the evening before, you will see, the tiny bubbles wil come at onle bigger, and then it's easy to push it outside.
i never warmed a vial. but my medecinchest is a dry place always at 8°.
when i prepare my seringue i let it one night in my medecine-set.
that way any carrier of oil will mix without prob. and also, i've notified than my injec are smoother.
TheMilkMan
New member
I routinely shoot over 2cc's into my glutes and quads... I don't go over 2cc's in my delts or pecs or 1cc in my biceps or triceps.
The smaller the gauge needle the better, if you can get away with 25g or even 27g do it, but with thick oil you may need to use 23g or 22g needles. The idea of using smaller needles is to minimize scar tissue.
Anything that needs to be shot with anything else IMO isn't even worth shooting.
The smaller the gauge needle the better, if you can get away with 25g or even 27g do it, but with thick oil you may need to use 23g or 22g needles. The idea of using smaller needles is to minimize scar tissue.
Anything that needs to be shot with anything else IMO isn't even worth shooting.
Similar threads
