One of my vials looks a little cloudy, advice?

[Nikknak]

I made 5 vials all from 1 batch, but only one of ten came out a tiny bit cloudy. Is this a big deal? Should I try to cut it down some more or not worry about it? No visible particles just not really clear like the rest. It's a mix of test and deca at 333mg/ml.

Thanks

 

[PITBULLLOCK]

Try worming it up with a blowdryer or warm water, Sounds like it just got to cold and it crashed.

 

[corvettels3]

was it the last one from your batch. your filter may have blown..

 

[ChrisWho?]

You may have not brought it fully into solution with enough heat. Try putting it on the stove and it should clear up.

 

[Nikknak]

Hmm it was the last vial... Blown filter? So maybe just re filter with a fresh one? It was only a 50ml batch though cheap filter!

 

[ChrisWho?]

You'd know if the filter blew out. Did it get very easy to push?

 

[Nikknak]

No not really, I'll try heating it up again. If I add something would Ethyl oleate or BB work better to hold it in suspension?

 

[corvettels3]

I would just refilter with a new filter and take it from there.

 

[jamesl0822]

What temp are you filtering at and what type of filter? If your gear was too hot (above 150F I like to filter mine at 100F) then you could have melted the filter a little. I would reheat and refilter all 50ml just to be safe. No need to cut it with more bb.