ok so i made a few ML of Test E with what powder i had left and this time i figured id try a 3% concentration of BA just to see what happens. evey pin i get sever test flu like low 100* fever body aches headaches just feel like shit and it lasts 24 hours comes on after 24 hrs from pin time. i also get sever PIP which comes on only 6 hours after pin a progresses to the worst part at 24 hrs then holds stead for 24 hours then starts to go away. i do also get swollen around injection site but never red or hot to the touch just a big lump with lots of pain. after researching im starting to think its because of the BA.
what i want to know is if anyone has done or knows for sure if you can "boil out' the BA? i looked up boiling points of all that is in there and luckily BA is the lowest at 406*F so i would think i would be safe to boil out only the BA right? also does anyone know if heating to this high of a temp will degrade the gear? will it be minimal or detrimental? i did make slightly stronger than 250mg/ml as i rouded up on the test powder just to use it all (this is for me only of course)
what i want to know is if anyone has done or knows for sure if you can "boil out' the BA? i looked up boiling points of all that is in there and luckily BA is the lowest at 406*F so i would think i would be safe to boil out only the BA right? also does anyone know if heating to this high of a temp will degrade the gear? will it be minimal or detrimental? i did make slightly stronger than 250mg/ml as i rouded up on the test powder just to use it all (this is for me only of course)